UCC283

具有反向電流保護(hù)功能的 3A、9V 超低壓降穩(wěn)壓器，-40°C 至 +85°C; ? Precision Positive Linear Series Pass Voltage Regulation\n? 0.45 V Dropout at 3 A\n? 50 mV Dropout at 10 mA\n? Quiescent Current Under 650 μA Irrespective of Load\n? Adjustable (5-Lead) Output Voltage Version\n? Fixed (3-Lead) Versions for 3.3-V and 5-V Outputs\n? Logic Shutdown Capability\n? Short-Circuit Power Limit of (3% × VIN × ISHORT)\n? Low VOUT to VIN Reverse Leakage\n? Thermal Shutdown;

The UCC283?3/?5/?ADJ family of positive linear series pass voltage regulators are tailored for low-drop-out applications where low quiescent power is important. Fabricated with a BiCMOS technology ideally suited for low input-to-output differential applications, the UCC283?5 passes 3 A while requiring only 0.45 V of typical input voltage headroom (ensured 0.6-V dropout).\n\n These regulators include reverse voltage sensing that prevents current in the reverse direction. Quiescent current is always less than 650 μA. These devices have been internally compensated in such a way that the need for a minimum output capacitor has been eliminated.\n\n UCC283?3 and UCC283?5 versions are in 3-lead packages and have preset outputs at 3.3 V and 5.0 V respectively. The output voltage is regulated to 1.5% at room temperature. The UCC283?ADJ version, in a 5-lead package, regulates the output voltage programmed by an external resistor ratio.\n\n Short-circuit current is internally limited. The device responds to a sustained overcurrent condition by turning off after a tON time delay. The device then stays off for a period, tOFF, that is 32 times the tON delay. The device then begins pulsing on and off at the tON/(tON +tOFF) duty cycle of 3%. This drastically reduces the power dissipation during short-circuit and means heat sinks need only accommodate normal operation. On the 3-leaded versions of the device tON is fixed at 750 μs, on the adjustable 5-leaded versions an external capacitor sets the on time. The off time is always 32 × tON. The external timing control pin, CT, on the 5-leaded versions also serves as a shutdown input when pulled low.\n\n Internal power dissipation is further controlled with thermal overload protection circuitry. Thermal shutdown occurs if the junction temperature exceeds 165°C. The chip remains off until the temperature has dropped 20°C.\n\n The UCC283 series is specified for operation over the industrial range of ?40°C to 85°C, and the UCC383 series is specified from 0°C to 70°C. These devices are available in 3- and 5-pin TO?220 and TO?263 power packages.

UCC283

Low Dropout 3 Ampere Linear Regulator Family

UCC283-3

Low Dropout 3 Ampere Linear Regulator Family

UCC283-3

LOW DROPOUT 3-A LINEAR REGULATOR FAMILY

UCC283-3

LOW-DROPOUT 3A LINEAR REGULATOR FAMILY

UCC283-3_12

LOW-DROPOUT 3-A LINEAR REGULATOR FAMILY

UCC283-3_16

LOW-DROPOUT 3A LINEAR REGULATOR FAMILY

UCC283-5

Low Dropout 3 Ampere Linear Regulator Family

UCC283-5

LOW DROPOUT 3-A LINEAR REGULATOR FAMILY

UCC283-5

LOW-DROPOUT 3-A LINEAR REGULATOR FAMILY