RTL8211FD-CG

INTEGRATED 10/100/1000M ETHERNET PRECISION TRANSCEIVER; ? 1000Base-T IEEE 802.3ab compatible\n? 100Base-TX IEEE 802.3u compatible\n? 10Base-T IEEE 802.3 compatible\n? Supports RGMII\n? Supports IEEE 802.3az-2010 (Energy Efficient Ethernet)\n? Built-in Wake-on-LAN (WOL)\n? Supports Interrupt function\n? Supports Parallel Detection\n? Crossover Detection & Auto-Correction\n? Automatic polarity correction\n? Supports PHYRSTB core power Turn-Off\n? Baseline Wander Correction\n? Supports 120m for CAT.5 cable in 1000Base-T\n? Selectable 3.3/2.5/1.8/1.5V signaling for RGMII\n? Supports 25MHz external crystal or OSC\n? Provides 125MHz clock source for MAC\n? Provides 3 network status LEDs\n? Supports Link Down power saving\n? Green Ethernet (1000/100Mbps mode only)\n? Built-in Switching LDO\n? 40-pin QFN Green package\n? 55 nm process with ultra-low power consumption\n? Industrial grade manufacturing process (RTL8211FDI-CG)\n;

The Realtek RTL8211FD-CG/RTL8211FDI-CG is a highly integrated Ethernet transceiver that is compatible with 10Base-T, 100Base-TX, and 1000Base-T IEEE?802.3 standards. It provides all the necessary physical layer functions to transmit and receive Ethernet packets over CAT.5 UTP cable. The RTL8211FDI-CG is manufactured to industrial grade standards.\n The RTL8211FD(I)-CG uses state-of-the-art DSP technology and an Analog Front End (AFE) to enable high-speed data transmission and reception over UTP cable. Functions such as Crossover Detection & Auto-Correction, polarity correction, adaptive equalization, cross-talk cancellation, echo cancellation, timing recovery, and error correction are implemented in the RTL8211FD(I)-CG to provide robust transmission and reception capabilities at 10Mbps, 100Mbps, or 1000Mbps.\n Data transfer between MAC and PHY is via the Reduced Gigabit Media Independent Interface (RGMII) for 1000Base-T, 10Base-T, and 100Base-TX. The RTL8211FD(I)-CG supports various RGMII signaling voltages, including 3.3, 2.5, 1.8, and 1.5V.\n The RTL8211FD(I)-CG incorporates a linear Low-Dropout Regulator (LDO) that features high power supply ripple rejection and low output noise. The built-in LDO means a power inductor is not required for the RTL8211FD(I)-CG; only an output capacitor is required between the 1.0V output and the analog ground for phase compensation, which saves cost and PCB real estate.\n

RTL8211FD-CG

INTEGRATED 10/100/1000M ETHERNET TRANSCEIVER

RTL8211FDI-CG

INTEGRATED10/100/1000METHERNETTRANSCEIVER

RTL8211FI-CG

INTEGRATED10/100/1000METHERNETTRANSCEIVER

RTL8211N-GR

INTEGRATED10/100/1000SINGLE/DUALGIGABITETHERNETTRANSCEIVER