MCP23S17-E/SO集成電路（IC）的I/O擴展器規格書PDF中文資料

MCP23S17-E/SO屬于集成電路（IC）的I/O擴展器。由微芯科技股份有限公司制造生產的MCP23S17-E/SOI/O 擴展器該系列器件可與微控制器、微處理器或類似器件結合使用，目的是增加可用于連接外設的信號連接數量。典型的工作概念涉及使用串行通信，只需主機設備上的幾根 I/O 線，即可讀/寫擴展器設備上的許多輸入/輸出引腳的狀態。該技術的通信速度不佳，但連通性較高，最適合快速響應不是很關鍵的應用，例如許多人機界面應用。

DEVICE OVERVIEW

The MCP23017/MCP23S17 (MCP23X17) device family provides 16-bit, general purpose parallel I/O expansion for I2C bus or SPI applications. The two devices differ only in the serial interface:

? MCP23017 – I2C interface

? MCP23S17 – SPI interface

The MCP23X17 consists of multiple 8-bit configuration registers for input, output and polarity selection. The system master can enable the I/Os as either inputs or outputs by writing the I/O configuration bits (IODIRA/B).

The data for each input or output is kept in the corresponding input or output register. The polarity of the Input Port register can be inverted with the Polarity Inversion register. All registers can be read by the system master.

Features

? 16-Bit Remote Bidirectional I/O Port:

- I/O pins default to input

? High-Speed I2C Interface (MCP23017):

- 100 kHz

- 400 kHz

- 1.7 MHz

? High-Speed SPI Interface (MCP23S17):

- 10 MHz (maximum)

? Three Hardware Address Pins to Allow Up to Eight Devices On the Bus

? Configurable Interrupt Output Pins:

- Configurable as active-high, active-low or open-drain

? INTA and INTB Can Be Configured to Operate Independently or Together

? Configurable Interrupt Source:

- Interrupt-on-change from configured register defaults or pin changes

? Polarity Inversion Register to Configure the Polarity of the Input Port Data

? External Reset Input

? Low Standby Current: 1 μA (max.)

? Operating Voltage:

- 1.8V to 5.5V @ -40°C to +85°C

- 2.7V to 5.5V @ -40°C to +85°C

- 4.5V to 5.5V @ -40°C to +125°C