dsPIC30F1010

SMPS 16-Bit Digital Signal Controller; High-Performance dsPIC30F coreUp to 30 MIPS operation\n? Modified Harvard architecture\n? C compiler optimized instruction set architecture\n? 24-bit wide instructions, 16-bit wide data path\nDSP Engine for math intensive operations\n? Modulo and Bit-Reversed modes\n? Two 40-bit wide accumulators with optional saturation logic\n? 17-bit x 17-bit single-cycle hardware fractional/ integer multiplier\nSingle-cycle Multiply-Accumulate (MAC) operation\n? 40-stage Barrel Shifter\n? Dual data fetch\nOperating Conditions3.3V and 5.0V operation (±10%)\n? Industrial and Extended temperature ranges\nPeripheral Features? High-current sink/source I/O pins: 25 mA/25 mA\n? Three 16-bit timers/counters; optionally pair up 16-bit timers into 32-bit timer modules\n? Four 16-bit Capture input functions\n? Two 16-bit Compare/PWM output functions (Dual Compare mode available)\n? 3-wire SPI? modules (supports 4 Frame modes)\n? I2C? module supports Multi-Master/Slave mode and 7-bit/10-bit addressing UART Module\nPower Supply PWM Module FeaturesFour PWM generators with 8 outputs\n? Each PWM generator has independent time base and duty cycle\n? Duty cycle resolution of 1.1 ns at 30 MIPS\n? Individual dead time for each PWM generator\n? Phase-shift resolution of 4.2 ns @ 30 MIPS\n? Frequency resolution of 8.4 ns @ 30 MIPS\n? Independent Current-Limit and Fault Inputs\n? Output Override Control\n? Special Event Trigger\n? PWM generated ADC Trigger\nAnalog Features10- bit ADC with 2000 Ksps conversion rate\n? Up to 12 input channels\n? “Conversion pairing” allows simultaneous conversion of two inputs (i.e., current and voltage) with a single trigger\n? PWM control loop with up to six conversion pairs where each conversion pair has up to four PWM and seven other selectable trigger sources\n? Interrupt hardware supports up to 1M interrupts per second\nComparator ? Four Analog Comparators with 20 ns response time and 10-bit DAC reference generator\n? PWM module interface with Duty Cycle Control, Period Control and Fault Detect\n? Special Event Trigger\n? PWM-generated ADC Trigger\nSpecial Microcontroller Features? Enhanced Flash program memory with 10,000 erase/write cycle (min.) for industrial temperature range, 100k (typical)\n? Self-reprogrammable under software control\n? Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)\n? Flexible Watchdog Timer (WDT) with on-chip low power RC oscillator for reliable operation\n? Fail-Safe clock monitor operation\n? Detects clock failure and switches to on-chip low power RC oscillator\n? Programmable code protection\n? In-Circuit Serial Programming? (ICSP?)\n? Selectable Power Management modes: Sleep, Idle and Alternate Clock modes;

dsPIC30F SMPS & Digital Power Conversion 16-bit Digital Signal Controller. These devices offer features supporting common, multi-loop digital switch-mode power supplies (SMPS) and other digital power-conversion applications such as:? AC to DC Converters? DC to DC Converters? Power Factor Correction (PFC)? Uninterruptible power supply (UPS)? Inverters? Embedded Power-Supply Controllers? Circuit Breakers, Arc Fault Detection? Digital Lighting

DSPIC30F1010

28/44-Pin High-Performance Switch Mode Power Supply Digital Signal Controllers

DSPIC30F1010

28/44-Pin High-Performance Switch Mode Power Supply Digital Signal Controllers

DSPIC30F1010

dsPIC30F1010/202X Data Sheet

DSPIC30F1010_14

28/44-Pin dsPIC30F1010/202X Enhanced Flash

DSPIC30F1010-20E

dsPIC30F1010/202X Data Sheet

DSPIC30F1010-20E

28/44-Pin High-Performance Switch Mode Power Supply Digital Signal Controllers

DSPIC30F1010-30E/PT

28/44-Pin High-Performance Switch Mode Power Supply Digital Signal Controllers

DSPIC30F1010-30E/S

28/44-Pin High-Performance Switch Mode Power Supply Digital Signal Controllers

DSPIC30F1010-30E/SO

28/44-Pin High-Performance Switch Mode Power Supply Digital Signal Controllers