CS2001

1.2 A Switching Regulator, and 5.0 V, 100 mA Linear Regulator with RESET

TheCS2001isasmartpowersupplyASICutilizedinautomotiveairbagsystems.Itcontainsacurrent–modeswitchingregulatorwitha1.2Aon–chipswitchanda5.0V,100mAlinearregulator.Thelinearoutputcapacitormustbe3.3μForgreaterwithanESRintherangeof100m?to1.0?.Ifthe

CS2001

1.2 A Switching Regulator, and 5.0 V, 100 mA Linear Regulator with RESET; ? Linear Regulator 5.0 V ±2% @ 100 mA\n? Switching Regulator 1.2 A Peak Internal Switch\n? Voltage Tripler\n? Smart Functions\n?? – Smartswitch\n?? – RESET\n?? – Energy Reserve Status\n? Protection\n?? – Overtemperature\n?? – Current Limit\n?? – 50 V Peak Transient Capability\n? Internally Fused Leads in SO–20L Package;

The CS2001 is a smart power supply ASIC utilized in automotive airbag systems. It contains a current–mode switching regulator with a 1.2 A on–chip switch and a 5.0 V, 100 mA linear regulator. The linear output capacitor must be 3.3 μF or greater with an ESR in the range of 100 m? to 1.0 ?. If the ESR of the cap is less than 100 m?, a series resistor must be used. The switcher can be configured in either a boost or flyback topology. The boost topology produces energy reserve voltage VER which is externally adjustable (25 V maximum) through the resistor divider connected to the VFB pin. In the event of fault conditions that produce VFB either open or shorted, the switcher is shut down.\nUnder normal operating conditions (VBAT 8.0 V), the current loading on the linear regulator is directed through VBAT. A low battery or loss of battery condition switches the supply for the linear regulator from VBAT to VER and shuts down the switcher using the ASIC’s internal “smartswitch.” This switchover feature minimizes the power dissipation in both the linear and switcher output devices and saves the cost of using a larger inductor.\nThe NERD (No Energy Reserve Detected) pin is a dual function output. If VOUT is not in regulation, it provides a Power On Reset function whose time interval is externally adjustable with the capacitor. This interval can be seen on the RESETB pin, which allows for clean power–up and power–down of the microprocessor. Once VOUT is in regulation, the logic level of the NERD output (usually low) indicates to the microprocessor whether or not the VER pin is connected.\nA switched–capacitor voltage tripler accepts input voltage VER and produces output voltage VCHG (typically VER + 8.0 V). This voltage is used in the system to drive high–side FETs.\nThis part is capable of withstanding a 50 V peak transient voltage. The linear regulator will not shut down during this event.

CS2001

三通道達林頓驅動電路; ● 單個通道灌電流最大可達500mA ● 輸出電壓最大可達50V ● 輸入信號TTL/5V CMOS兼容 ● 輸出端集成鉗位二極管 ● 廣泛用于繼電器驅動;

CS2001是一款單片集成的高壓、大電流的達林頓管陣列驅動電路，內含三組NPN達林頓管。每個通道輸出端均集成了一個鉗位二極管，用于驅動感性負載時起保護作用。單個通道輸出電流最大可達500mA，并聯可實現更高的輸出電流能力

CS2001YDWF20

1.2 A Switching Regulator, and 5.0 V, 100 mA Linear Regulator with RESET

TheCS2001isasmartpowersupplyASICutilizedinautomotiveairbagsystems.Itcontainsacurrent–modeswitchingregulatorwitha1.2Aon–chipswitchanda5.0V,100mAlinearregulator.Thelinearoutputcapacitormustbe3.3μForgreaterwithanESRintherangeof100m?to1.0?.Ifthe

CS2001YDWFR20

1.2 A Switching Regulator, and 5.0 V, 100 mA Linear Regulator with RESET

TheCS2001isasmartpowersupplyASICutilizedinautomotiveairbagsystems.Itcontainsacurrent–modeswitchingregulatorwitha1.2Aon–chipswitchanda5.0V,100mAlinearregulator.Thelinearoutputcapacitormustbe3.3μForgreaterwithanESRintherangeof100m?to1.0?.Ifthe

CS2001CB/CP

三通道達林頓驅動電路;

CS2001YDWFR20

Package：20-SOIC（0.295"，7.50mm 寬）；包裝：管件 類別：集成電路（IC） 線性穩壓器控制器 描述：IC REG DL BUCK/LNR SYNC 20SOIC

CS2001YDWFR20

Package：20-SOIC（0.295"，7.50mm 寬）；包裝：管件 類別：集成電路（IC） 穩壓器 - 線性 + 開關 描述：IC REG DL BUCK/LNR SYNC 20SOIC